Concorde V6-2.7L VIN V (2001)
Water Pump: Service and Repair
REMOVAL
The water pump on all models can be replaced without discharging the air conditioning system.
NOTE: It is normal for the water pump to weep a small amount of coolant from the weep hole (black stain at weep passage). Do not replace the water
pump if this condition exists. Replace the water pump if a heavy deposit or a steady flow of engine coolant is evident on side of the cylinder block
from the weep hole passage (shaft seal failure). Be sure to perform a thorough analysis before replacing water pump.
WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND PRESSURIZED. SERIOUS BURNS FROM
COOLANT CAN RESULT.
1. Drain cooling system.
2. Remove radiator upper crossmember.
3. Remove radiator fan.
4. Remove accessory drive belts.
NOTE: The water pump is driven by the primary timing chain.
5. Remove the timing chain and all chain guides. .
6. Remove bolts attaching water pump to block.
7. Remove water pump and gasket.
INSPECTION
Inspect and replace the water pump if it has any of the following defects:
1. Damage or cracks on the pump body.