Concorde V6-2.7L VIN V (2001)
Fig.17 Mode Door Actuator Location
7. Remove the actuator retaining screws. Then pull the actuator straight down. Upon removal, note the shaft position of the actuator, because the
shaft on this motor is keyed. When installing a new actuator, its shaft must be positioned in the same location.
8. Remove the electrical connection on the actuator.
INSTALLATION
1. Connect the wire harness connector to the mode door actuator.
2. Install the mode door actuator on the HVAC housing, making sure its keyed shaft is positioned properly.
3. Install the three fastener screws and tighten to 2.2 Nm (20 in. lbs.).
4. Reposition the center support bracket and install fastener.
5. Install the rear seat heat forward adaptor duct.
6. Install the center floor heat adaptor duct.
7. Install the floor console.
8. Install the left and right underpanel ducts.
9. Connect the negative battery cable remote terminal to the remote battery post.
