Concorde V6-2.7L VIN V (2001)
Compressor Clutch: Service and Repair
After new clutch installation, cycle the A/C clutch 20 times (5 seconds ON and 5 seconds OFF). During this procedure, set the system to the A/C mode,
engine rpm at 1500 - 2000, and high blower speed. This procedure (burnishing) will seat the opposing friction surfaces and provide a higher clutch
torque capability.
NOTE: Excessive clutch gap will result in clutch slippage or non-engagement.
REMOVAL
The refrigerant system can remain fully-charged during compressor clutch, pulley, or coil replacement. The compressor clutch can be serviced in the
vehicle.
1. Disconnect and isolate the battery negative cable.
2. Remove the serpentine drive belt. Refer to Cooling for the procedures.
3. Unplug the compressor clutch coil wire harness connector.
4. Remove the bolts that secure the compressor to the mounting bracket.
5. Remove the compressor from the mounting bracket. Support the compressor in the engine compartment while servicing the clutch.
Fig.1 Compressor Shaft Bolt And Clutch Plate
6. Remove the compressor shaft bolt. A band type oil filter removal tool can be placed around the clutch plate to aid in bolt. removal.
