Concorde V6-2.7L VIN V (2001)
Fig.4 Clutch Coil Snap Ring
10. Remove snap ring retaining field coil onto compressor housing. Slide field coil OFF of compressor housing.
INSTALLATION
1. Align pin in back of field coil with hole in compressor end housing, and position field coil into place. Make sure that lead wires are properly
routed, and fasten the diode and coil wire bracket with retaining screw.
2. Install field coil retaining snap ring with Snap Ring Pliers (C- 4574). Press snap ring to make sure it is properly seated in the groove.
NOTE: The bevel side of the snap ring must be out- ward. Also both eyelets must be to the right or left of the pin on the compressor.
CAUTION:
-
If snap ring is not fully seated it will vibrate out, resulting in a clutch failure and severe damage to the front face of the compressor.
-
Do not mar the pulley frictional surface.
