Concorde V6-2.7L VIN V (2001)
Refrigerant Pressure Sensor / Switch: Service and Repair
Fig.10 Negative Battery Cable Remote Terminal
REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Disconnect the wire harness connector from the a/c pressure transducer.
CAUTION:
-
A slight release of pressure trapped in the fitting may be experienced. It is not necessary to discharge the refrigerant system.
3. Remove the transducer with a counterclockwise rotation using a 14 mm open-end wrench.
INSTALLATION
1. Install the a/c pressure transducer on the discharge line fitting and tighten to 6 Nm (50 in. lbs.).
2. Plug in the wire harness connector to the a/c pressure transducer.
3. Connect the battery negative cable to the remote battery post.