Concorde V6-2.7L VIN V (2001)
Glove Box Lamp Switch: Service and Repair
REMOVAL
Negative Battery Cable Remote Terminal
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
Fig.4 Glove Box Lamp/Switch
2. Open the glove box door, using a trim stick (special tool #C-4755) or equivalent, gently pry out on the glove box lamp/switch assembly from
upper right hand corner of opening.
3. Disconnect the wire connector.
INSTALLATION
1. Connect the electrical connector to the new glove box lamp/switch.
2. Place glove box lamp/switch assembly into position, firmly snap into place, and close the glove box door.
3. Connect the negative battery cable remote terminal to the remote battery post.
