Concorde V6-2.7L VIN V (2001)
WARNING: THE AIRBAG MUST BE INSIDE THE NYLON SLEEVE BEFORE INSTALLING THE RETAINING NUTS. FAILURE
TO DO SO WILL ADVERSELY AFFECT THE FUNCTIONALITY OF THE SIDE AIRBAG SYSTEM.
2. Pull airbag and nylon sleeve assembly up, to line up mounting studs and mistake proofing pin with holes provided in seat back frame mounting
bracket. Install airbag retaining nuts. Torque to 10.7 ± 1 Nm (94.7 in. lbs.).
3. Connect the side airbag electrical connector. After the initial connector is installed, be certain the yellow locking tab is in the upper "LOCKED"
position. Check to be certain the connector cannot be removed once the yellow locking tab is positioned.
4. Reposition the seat back trim cover by pulling down over seat back frame, and install the seat back trim cover J-straps on the upper, lower, and
airbag side of seat back frame.
CAUTION: Always install new push pins when installing the seat back plastic panel.
5. Install the plastic back panel on the seat back. Be sure to use new push pins in the upper mounting location of the back cover. Refer to Body,
Seats, Seat Back, INSTALLATION.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE REMOTE TERMINAL. REFER TO ELECTRICAL,
RESTRAINTS, DIAGNOSIS AND TESTING - AIRBAG SYSTEM FIRST.