Concorde V6-2.7L VIN V (2001)
Wiper Switch: Testing and Inspection
Fig.16 Wiper Switch Location
Fig.17 Multi-Function/Wiper Switch Pin Call Out
To test the multi-function/wiper switch, first disconnect the switch wires from the body wiring in the steering column. Using an ohmmeter, test for
continuity between the terminals of the switch, as indicated in the following continuity table. The identity of each terminal is shown in figure.
For test purposes, the first position is the OFF position, the next six positions are for the DELAY wipe. LOW is the next detent position and HIGH is the
full counterclockwise detent position.
In any wiper switch position, if the control stalk end cap is depressed, the washer circuit will be completed.