Concorde V6-2.7L VIN V (2001)
Valve Body: Service and Repair
Valve Body
Removal
REMOVAL
NOTE: If valve body is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure.
(1) Disconnect the TRS wiring connector. The solenoid wiring connector can remain attached to the case.
(2) Disconnect the shift cable from the shift lever (at the transaxle).
(3) Move the shift lever clockwise as far as it will go. This should be one position past the L position. Then remove the shift lever.
(4) Remove transaxle pan bolts (Fig. 375).
(5) Remove transaxle oil pan (Fig. 376). When reinstalling oil pan be sure that pan flange is clean and oil free. Apply a 1/8 inch bead of Mopar
Silicone Sealer onto oil pan flange before installing.