Concorde V6-2.7L VIN V (2001)
(5) Clamp sealing boot on interconnecting shaft using Crimper, Special Tool C-4975 and the procedure. Place crimping tool C-4975 over bridge of
clamp (Fig. 34). Tighten nut on crimping tool C-4975 until jaws on tool are closed completely together, face to face (Fig. 35).
CAUTION: Seal must not be dimpled, stretched or out of shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and shape
it by hand.
(6) Position outer C/V joint seal boot, into boot retaining groove on outer C/V joint housing. Install seal boot to outer C/V joint retaining clamp
evenly on sealing boot.