Concorde V6-2.7L VIN V (2001)
7. Remove hub and bearing assembly from steering knuckle by sliding it straight out of steering knuckle and off end of stub axle. If hub and bearing
assembly will not slide out of knuckle, insert a pry bar between hub and bearing assembly and steering knuckle and gently pry hub and bearing
from knuckle. If stub shaft is frozen to hub and bearing assembly, tap end of stub shaft with soft face hammer to free it form hub and bearing
spline.
CAUTION: If metal seal on hub and bearing assembly is seized to steering knuckle and becomes dislodged on hub and bearing assembly during
bearing removal. The hub and bearing assembly MUST not be reused and MUST be replaced with a new hub and bearing assembly.
INSTALLATION-HUB AND BEARING (FRONT)