Concorde V6-2.7L VIN V (2001)
Windshield Washer Motor: Service and Repair
REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Hoist vehicle.
3. Remove front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to Body for Removal.
4. Disconnect the wire connectors from the reservoir pump.
Fig.6 Washer Reservoir
5. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
6. Remover rubber grommet from reservoir and throw away.
INSTALLATION
1. Install new rubber grommet in reservoir.
2. Carefully install pump motor into reservoir. Care must be taken not to puncture reservoir.
3. Connect the wire connectors to the reservoir pump.
4. Install the front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to Body for Installation.
5. Lower vehicle from hoist.
6. Connect the negative battery cable remote terminal to the remote battery post.
