Concorde V6-201 3.3L VIN T FI (1993)
1. Install install passenger airbag module to the collar bracket with six mounting screws and torque to 35 inch lbs.
2. Install instrument panel with passenger airbag module into vehicle.
3. Install upper steering column bracket nuts and lower bolts.
4. Connect all electrical connectors.
5. Install instrument panel top cover assembly.
6. Install right and left knee bolster to upper instrument panel.
7. Open glove box and install four screws attaching module to knee bolster and torque to 20 inch lbs.
8. Do not connect battery ground cable. Refer to Testing and Inspection/Procedures.
Undeployed Module
WARNING: Before attempting to diagnose, remove or install any airbag system components, unless otherwise noted, you must first disconnect
and isolate battery ground cable. Failure to do so could result in accidental deployment and possible personal injury.
WARNING: If replacing a deployed module, wear gloves and eye protection. There will be deposits on and around the airbag that could cause
skin and eye irritation. If material does come into contact with the body, flush with plenty of cold water.
Fig. 177 Airbag Module Attaching Screws - Removal
NON DEPLOYED PASSENGER SIDE AIRBAG
1. Disconnect and isolate battery ground cable. Wait minimum of 2 minutes before working on vehicle.
2. Open glove box and push side inward to allow door bumper to pass and allow box to open fully.
3. Remove the four module attaching screws from inside glove box opening.
4. Remove knee bolster and right spot cooler.
5. Disconnect wire connector from module.
6. Lift module up and turn it so it can be lowered through the mounting brackets.
7. Reverse procedure to install.
