Concorde V6-3.2L VIN J (2000)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Removal and Installation
NOTE: Before proceeding with this procedure, review Service Precautions.
REMOVAL
1. Remove the remote ground cable from the ground stud on the right strut tower.
Correctly Isolated Remote Ground Cable
2. Correctly isolate remote ground cable when servicing vehicle by installing the ground cable insulator on the strut tower ground stud as shown and
installing the nut on the stud. This will prevent accidental grounding of the remote round cable.
3. Using a brake pedal positioning tool such as shown depress brake pedal past its first 1 inch of travel and hold in this position. This will isolate the
master cylinder reservoir from the brake hydraulic system, not allowing the brake fluid to drain out of the reservoir.
4. Remove the bolt and 2 nuts securing the speed control servo to vehicle. Disconnect the wire harness connector from speed control servo. Leaving
the cable attached to the speed control servo, move it aside, out of the way.