Concorde V6-3.2L VIN J (2000)
Spark Plug Tube Seal - Valve Cover: Service and Repair
REMOVAL
1. Remove cylinder head cover(s). Refer to Engine.
2. Using locking pliers remove the tube from the cylinder head. Discard old tube.
3. Clean area around spark plug with Mopar(R) Parts Cleaner or equivalent.
4. Refer to Engine, Cylinder Head Assembly, Valve Cover for spark plug tube seal replacement.
INSTALLATION
1. Apply Mopar(R) Stud and Bearing Mount to a new tube approximately 1 mm (0.039 inch) from the end of tube, in a 3 mm (0.118 inch) wide
area.
2. Install sealer end of tube into the cylinder head. Then carefully install the tube using a hardwood block and mallet. Install the tube until it is seated
into the bottom of the bore.
3. Install cylinder head cover(s).