Concorde V6-3.2L VIN J (2000)
![background image](/chrysler/concorde/v6-3.2l_vin_j/Page-1755002.png)
3. Remove two screws from actuator which are accessible from the right side of center stack.
4. Remove one screw from actuator on left side.
5. Pull actuator straight down from shaft and disconnect electrical connection. Upon removal, note the shaft position of the actuator, because the
shaft on this motor is keyed. When installing new actuator, its shaft must be positioned in the same location.
INSTALLATION
For installation, reverse the above procedures.