Concorde V6-3.2L VIN J (2000)
Level Sensor Installation
2. Wrap wires into groove in back of level sensor.
3. while feeding wires into stand pipe, slide level sensor up into installation channel until it snaps into place. Ensure tab at bottom of sensor locks in
place.
4. Install level sensor wires in connector. Push the wires up through the connector and then pull them down until they lock in place. Ensure signal and
ground wires are installed in the correct position.
5. Install retaining clip on connector.
6. Push fuel pump/level sensor connector up into bottom of fuel pump module electrical connector.
7. Install fuel pump module.