Concorde V6-3.2L VIN J (2000)
Wheel Fastener: Service and Repair
Front
CAUTION: If a wheel attaching stud needs to be replaced in the hub and bearing assembly, DO NOT be hammer them out of the hub flange. If a stud is
removed by hammering it out of the bearing flange, damage to the hub and bearing assembly will occur leading to premature bearing failure.
NOTE: The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing
assembly.
REMOVAL
1. Raise vehicle on jackstands or centered on a frame contact type hoist.
2. Remove the 2 guide pin bolts mounting the caliper assembly to the steering knuckle. Remove the caliper from the front steering knuckle. Refer to
Disc Brake Caliper Brakes and Traction Control for the caliper removal procedure.