Concorde V6-3.5L VIN V (2003)
8. Install the caliper guide pin bolts. Tighten guide pin bolts to a torque of 22 Nm (192 inch lbs.).
9. Repeat the preceding steps on the opposite side of the vehicle, installing the brake shoes on that side of the vehicle.
10. Install the wheel and tire assemblies.
11. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 135 Nm (100 ft. lbs.).
12. Lower vehicle.
CAUTION: After performing any service to the vehicle brake system, be sure to obtain a firm brake pedal before moving vehicle.
13. Pump the brake pedal several times to ensure the vehicle has a firm brake pedal to adequately stop vehicle.
14. Check and adjust the brake fluid level as necessary.
15. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
INSTALLATION - FRONT DISC BRAKE SHOES (EXPORT)
1. Completely retract caliper piston back into piston bore of caliper assembly.
2. Lubricate both steering knuckle abutments with a liberal amount of Mopar Brake Grease For Caliper Slides Lubricant, or equivalent.
3. Remove the protective paper from the noise suppression gasket on both the inner and outer brake shoe assemblies (if equipped).
NOTE: The inboard and outboard brake shoes are not common, refer to for inboard and outboard brake shoe assembly identification.
NOTE: When installing inboard brake shoe into caliper piston, be sure brake shoe is positioned squarely against the face of the caliper piston.
4. Install the new inboard brake shoe assembly into the caliper piston by firmly pressing it into bore of caliper piston with thumbs.
5. Slide the new outboard brake shoe assembly onto the caliper assembly.
6. Carefully position caliper and brake shoes over rotor by reversing the removal procedure.
CAUTION: When being installed, extreme caution should be taken not to crossthread the caliper guide pin bolts.
7. Install the caliper guide pin bolts. Tighten guide pin bolts to a torque of 22 Nm (192 inch lbs.).
8. Repeat the preceding steps on the opposite side of the vehicle, installing the brake shoes on that side of the vehicle.
9. Install the wheel and tire assemblies.
10. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 135 Nm (100 ft. lbs.).
11. Lower vehicle.
CAUTION: After performing any service to the vehicle brake system, be sure to obtain a firm brake pedal before moving vehicle.
12. Pump the brake pedal several times to ensure the vehicle has a firm brake pedal to adequately stop vehicle.
13. Check and adjust the brake fluid level as necessary.
14. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
Removal and Installation - Export
REMOVAL - FRONT DISC BRAKE SHOES (EXPORT)
1. Raise vehicle.
2. Remove both front wheel and tire assemblies from vehicle.
3. Remove the two caliper guide pin bolts.