Concorde V6-3.5L VIN V (2003)
5. Using a 1-5/16 inch crow foot, loosen the solenoid control valve. Then, by hand, remove the solenoid control valve from the power steering gear.
INSTALLATION - SOLENOID CONTROL VALVE
1. Inspect the O-ring seals on the solenoid control valve to be sure they are not damaged. If the O-rings are not damaged, moisten the O-rings using
only fresh clean Mopar Power Steering Fluid, or equivalent.
2. Install the solenoid control valve into the steering gear by hand until it is fully seated into the steering gear.
3. Using the 1-5/16 inch crow foot as shown, tighten the solenoid control valve to a torque of 14 Nm (124 inch lbs.).