Concorde V6-3.5L VIN V (2003)
a. Slide the end of the steering gear through the tie rod hole in the right side inner fender. Steering gear needs to be slid through tie rod hole until
about half of the steering gear is through the hole.
b. Lift the left end of the steering gear upward, with the steering gear positioned as shown, between the back of the engine and the front of the
cowl.
c. To remove the steering gear from the vehicle, pull the steering gear toward the passenger side of the vehicle out from between the cowl and the
engine.
Installation
INSTALLATION - POWER STEERING GEAR
NOTE: When the original or a replacement steering gear is being installed in vehicle, be sure the tie rod attachment at the steering gear is in the
center of steering gear travel.
1. Install the steering gear in the vehicle using the reverse sequence of the removal steps.
NOTE: If the vehicle is equipped with a 2.7 Liter engine, position the left front tire so it is facing straight forward.
2. Install the right tie rod through the tie rod hole in the inner fender.