Concorde V6-3.5L VIN V (2003)
![background image](/chrysler/concorde/v6-3.5l_vin_v/Page-1868005.png)
12. Remove the strut assembly to steering knuckle attaching bolts.
13. Remove the steering knuckle from the vehicle.
INSTALLATION - STEERING KNUCKLE
Fig. 10 Ball Joint Stud To Steering Knuckle Clamp Nut And Bolt Removal
1. Install steering knuckle on ball joint stud. Install steering knuckle to lower ball joint attaching bolt and nut into steering knuckle. Tighten the
attaching bolt to a torque of 55 Nm (40 ft. lbs.).
2. Position steering knuckle into strut assembly.
CAUTION: The strut assembly to steering knuckle bolts are serrated were they go through strut assembly and steering knuckle. When installing
bolts, turn nuts onto bolts DO NOT TURN BOLTS IN STEERING KNUCKLE. If bolts are turned damage to steering knuckle will result.