Crossfire V6-3.2L VIN L (2004)
Garage Door Opener Transmitter: Programming and Relearning
ERASING CODES
To erase previously programmed Garage Door Opener codes, simply hold down the two outside buttons until the red LED begins to flash.
PROGRAMMING CODES
1. Turn off the engine.
2. Erase the factory test codes by pressing the two outside buttons. Release the buttons when the red light begins to flash.
3. Choose one of the three buttons to program. Place the manufacturer s hand-held transmitter within one inch of the vehicle Universal Garage Door
Opener and push the buttons on both transmitters. The red light on the Universal Garage Door Opener will begin to flash slowly.
4. When the red light on the Universal Garage Door Opener begins to flash rapidly (this may take as long as 60 seconds), release both buttons. The
Universal Garage Door Opener is now programmed. Advise the vehicle owner to be sure to keep the manufacturer s hand-held transmitter in case
it is needed to reprogram the Universal Garage Door Opener.