Crossfire V6-3.2L VIN L (2004)
Fuse Block: Service and Repair
Underhood Accessory Fuse Block
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the lid to the underhood accessory fuse block.
3. Push the front of the underhood accessory fuse box forward releasing the tabs (1) on the underhood fuse block.
4. Pull the underhood accessory fuse block out of the box and remove all of the underhood accessory fuse block harness connectors.
INSTALLATION
1. Install the harness connectors to the underhood accessory fuse block.
2. Push the underhood accessory fuse block down into the box until the rear tabs and the front two tabs connect.
3. Install the lid.
4. Connect the negative battery cable.