Crossfire V6-3.2L VIN L (2004)
Keyless Entry Module: Service and Repair
Sentry Key Remote Entry Module
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the instrument cluster.
3. Disconnect the 2-pin CAN bus harness connector (1) from the SKREEM.
4. Disconnect the 2-pin harness connector for the sentry key antenna ring.
5. Disconnect the 18-pin harness connector (1) from the SKREEM.
6. Press the retaining tabs apart.
7. Remove the SKREEM from the base plate.
INSTALLATION
1. Install the SKREEM to the base plate.
2. Connect the 18-pin harness connector and the 2-pin CAN bus harness connector (1) to the SKREEM.
3. Connect the 2-pin harness connector for the sentry key antenna ring.
4. Install the instrument cluster.
5. Connect the negative battery cable.