Crossfire V6-3.2L VIN L (2004)
Oxygen Sensor: Service and Repair
UPSTREAM O2 SENSOR
REMOVAL
Note: The left side O2 sensor is shown. The right side is similar.
1. Disconnect the negative battery cable.
2. Remove the air cleaner housing.
3. Disconnect the O2 sensor harness connector.
4. Remove the O2 sensor (1).
INSTALLATION
1. Apply anti-seize compound to the threaded portion of the O2 sensor.
2. Install the O2 sensor (1). Tighten to 50 N.m (37 ft. lbs.).
3. Connect the O2 sensor harness connector.
4. Install the air cleaner housing.
5. Connect the negative battery cable.
DOWNSTREAM O2
REMOVAL