Crossfire V6-3.2L VIN L (2004)
1. Install the new output flange seal (1) using Special Tool 9122 Drift (2) and a mallet.
2. Install the output flange (3) and nut. Hold the flange (3) with Special Tool C-3281 Flange Wrench (2). Tighten the nut to 180 Nm (133 ft. lbs.).
Note: The Special Tool 9078 has two possible locations for the beveled staking pin. The pin must be installed in the hole labeled "Transmission"
for this operation. This hole is located directly across from the spring loaded alignment pin.
3. Stake the output shaft nut to the output shaft as follows.
a. Place the Special Tool 9078 Staking Tool (2) onto the output shaft.
b. Rotate the Special Tool 9078 Staking Tool (2) until the alignment pin (3) engages the output shaft notch (4).
