Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Tires: Procedures
Cleaning
CLEANING
Note: DO NOT use gasoline, mineral oil, oil-based solvent or a wire brush for cleaning.
Remove the protective coating on the tires before delivery of a vehicle. This coating may cause deterioration of the tires.
To remove the protective coating, apply warm water and let it soak for a few minutes. Afterwards, scrub the coating away with a soft bristle brush.
Steam cleaning may also be used to remove the coating.
Draining Tirefit
STANDARD PROCEDURE - DRAINING TIREFIT
WARNING: KEEP AWAY FROM FIRE, SPARKS OR NAKED FLAME. DO NOT SMOKE WHILE HANDLING A TIRE THAT HAS
BEEN INFLATED USING TIREFIT. DO NOT INHALE VAPORS. CALL A PHYSICIAN IMMEDIATELY IF AN ALLERGIC
REACTION OCCURS. KEEP TIREFIT AWAY FROM CHILDREN. IF SWALLOWED, INDUCE VOMITING AND CALL A
PHYSICIAN IMMEDIATELY. THE TIRE SEALANT MUST NOT COME INTO CONTACT WITH THE SKIN, EYES OR CLOTHING,
RINSE IMMEDIATELY WITH CLEAN WATER.
TIREFIT sealant can be used on the roadside to seal minor punctures, in particular in the tread. The tire can then continue to be used to a limited
extent until it can be replaced. After using TIREFIT tire sealant the customer is required to find the nearest authorized DaimlerChrysler service center
immediately and replace the damaged tire with a new one. Tires which have been treated with TIREFIT tire sealant must not be repaired. They must
always be replaced with new tires of the same make and manufacturer. To avoid an odor due to TIREFIT, relieve the tire pressure out in the open.
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly from the vehicle.
Note: Raise the wheel off the ground approximately 8 - 10 inches off the ground to allow the TIREFIT to be forced by gravity.
3. Position the wheel and tire assembly so that the air valve is pointing downwards for approximately ten minutes.
WARNING: THE TIRE SEALANT MUST NOT COME INTO CONTACT WITH THE SKIN, EYES OR CLOTHING, RINSE
IMMEDIATELY WITH CLEAN WATER.
4. Remove the valve stem with the appropriate tool, allow the tire pressure to escape from the tire.
5. Remove the valve from the wheel.
6. Attach the hose from the TIREFIT container to the plastic bottle.
7. Squeeze the container and immerse the hose as deep as possible in the tire sealant through the valve bore in the wheel.
8. Remove the sealant by sucking it out of the tire with the container until all of the TIREFIT sealant is removed. This will generally remove 90% of
the TIREFIT sealant.
9. Remove the tire from the wheel.
10. Clean the wheel making sure it is free of the TIREFIT sealant.
11. Install a new tire to the wheel.
12. Install the wheel and tire assembly to the vehicle.