Lebaron Convertible L4-153 2.5L SOHC VIN K TBI (1986)
![background image](/chrysler/lebaron_convertible/l4-153_2.5l_sohc_vin_k_tbi/Page-506005.png)
FIGURE 3
-
Disconnect injector wiring harness connector at locations shown in
Figure 3.
-
Ground one terminal of the throttle body side connector.
-
Connect a jumper wire to second terminal and touch the battery positive post for no longer than 10 seconds. This releases system
pressure.
-
Remove the jumper wires but leave the wiring harness disconnected.
3.
Remove #20 Torx screw holding down the injector cap.
FIGURE 4
4.
With two small screwdrivers, lift the cap off the injector using the slots provided
(Figure 4).
FIGURE 5