Lebaron Coupe L4-135 2.2L SOHC Turbo VIN A FI (1989)
Speed Control Servo: Testing and Inspection
Fig. 72 Servo Harness Connector
1. Turn ignition switch to On position.
2. With speed control switch in On position, connect voltmeter negative lead to a chassis ground.
3. Disconnect 4-way connector at servo.
4. If battery voltage is not present at pin 2 of main harness 4-way connector, check and repair loose or damaged connectors or harness.
5. Connect a suitable jumper wire between pin No. 2 of 4-way connector and pin No. 2 of speed control servo.
6. In battery voltage is not present at remaining pin at servo, replace speed control servo.
7. Using suitable ohmmeter, connect negative lead to chassis ground and positive lead to pin 1 of 4-way connector.
8. If continuity does not exist, check and repair loose or damaged connectors or harness.