Lebaron Coupe L4-135 2.2L SOHC Turbo VIN A FI (1989)
1) are not contacting the crossmember. If washer-to-crossmember clearance is sufficient, and a squeak is still present, proceed with the following repair.
<<
PARTS REQUIRED
1
Exhaust Seal Ring
PN 4427699
2
Bolts, Flange to Manifold
PN 5217003
2
Nuts, Flange to Manifold
PN 4427610
REPAIR PROCEDURE
This procedure involves replacement of the exhaust-manifold-to-exhaust-pipe sealing ring with a revised seal ring.
1.
Using Figure 3 on Page 11-2 of the 1990 Front Wheel Drive Car Service Manual (Publication # 81-270-0101) for reference, disconnect the
exhaust pipe from the exhaust manifold and remove the exhaust seal ring.
2.
Install the revised seal ring, and connect the exhaust pipe to the exhaust manifold, using new bolts and nuts as called out in PARTS
REQUIRED. Tighten to 28 N-m (250 in.lbs.) torque.
NOTE:
THE NEW SEAL RING WILL FIT LOOSELY ON THE PIPE. DO NOT RESIZE THE PIPE TO FIT THE SEAL RING
TIGHTLY.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
11-20-05-92
. . . . . . . . . . . . . . . . .
0.3 Hrs.
FAILURE CODE:
68 - Noisy