Lebaron Coupe L4-135 2.2L SOHC Turbo VIN E FI (1987)
9.
Install trim cover, PN 4476258. Slide it over the seat belt anchor plate and bolt.
10.
Repeat Steps 6 through 9 for the other side.
Lower Rear Shoulder Belt Installation
1.
Remove the rear seat cushion and the attaching bolts (one per side) for the lower inner lap seat belts (Figure 15).
NOTE:
DO NOT REMOVE OR REARRANGE THE EXISTING SEAT BELTS.
2.
Discard the existing bolts and substitute the red colored bolts, PN 6031216, in Step 3 (K-15 is on the bolt head).
3.
Install lower shoulder belts, PN 4476257, on top of the existing lower inner seat belts and tighten the new bolts to 350 inch pounds torque (Figure
15). The white label on the seat belt should face down. Reinstall seat cushion.
CAUTION: CHECK THAT BOTH THE LAP AND SHOULDER BELTS LATCH AND UNLATCH PROPERLY AND ARE INSTALLED
AS SHOWN IN FIGURE 15. MAKE SURE THAT THE SEAT BELTS DO NOT CONTACT ANY SHARP EDGES THAT
COULD CUT THE WEBBING.
H-Body 4-Door (Dodge Lancer and Chrysler LeBaron GTS)
CAUTION:
THIS PACKAGE IS ONLY FOR DEALER INSTALLATION IN 1985 AND LATER MODELS LISTED ABOVE. DO NOT
ATTEMPT INSTALLATION IN ANY OTHER VEHICLE. FOLLOW THESE INSTRUCTIONS CAREFULLY AND USE
ONLY THE SPECIFIED PARTS.