Pacifica V6-3.8L (2008)
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Brakes - Caution
1. Disconnect and isolate battery negative cable from battery post.
2. Using a brake pedal holding tool as shown, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this
position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake
lines are open.
3. Raise and support vehicle. See: Maintenance
4. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
NOTE: In some cases, it may be necessary to retract caliper piston in its bore a small amount in order to provide sufficient clearance
between shoes and rotor to easily remove caliper from knuckle. This can usually be accomplished before guide pin bolts are removed, by
grasping rear of caliper and pulling outward working with guide pins, thus retracting piston. Never push on piston directly as it may get
damaged.