Pacifica V6-3.8L (2008)
1. Install disc brake caliper over brake pads on brake caliper adapter.
CAUTION: To avoid possible noise or roughness concerns, it is crucial that upper caliper guide pin bolt (closest to bleeder screw) be
tighten to specifications first before tightening lower guide pin bolt.
2. Align caliper guide pin bolt holes with guide pins, then install caliper guide pin bolts (4). Tighten upper (closest to bleeder screw) bolt to 43 Nm
(32 ft. lbs.), then tighten lower bolt to 43 Nm (32 ft. lbs.).
3. Install banjo bolt (7) attaching brake hose to caliper. Install NEW washers (5) on each side of hose fitting as banjo bolt (7) is placed through
fitting. Thread banjo bolt into caliper and tighten to 47 Nm (35 ft. lbs.).
4. Install tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).