Pacifica V6-3.8L (2008)
Parking Brake Cable: Service and Repair
Parking Brake Cable - Removal
Front
REMOVAL
1. Disconnect and isolate battery negative cable from battery post.
2. Lock out automatic adjuster in parking brake lever. See: Service and Repair
3. Raise and support vehicle. See: Maintenance
NOTE: It may be necessary to back off parking brake shoe adjustment to allow sufficient slack to disengage cable buttons from
connectors in following two steps.
4. Slide left rear cable button (11) inboard and remove from equalizer (10).
5. While holding cable connector on end of front cable (5) secure with a pair of pliers at the front cable button, slide right rear cable button (4)
inboard and remove from cable connector.
6. Slide equalizer (2) off front cable housing (3) and remove.