Pacifica V6-3.8L (2008)
Control Assembly: Removal and Replacement
A/C Heater Control - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel from the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel - Removal.
3. Remove the three screws (2) that secure the A/C-heater control (1) to the instrument panel (3).
4. Remove the A/C-heater control from the instrument panel and disconnect the two wire harness connectors from the control.
A/C Heater Control - Installation
INSTALLATION
1. Position the A/C-heater control (1) to the instrument panel (3).
2. Connect the two wire harness connectors to the back of the A/C-heater control.
3. Install the A/C-heater control into the instrument panel.
4. Install the three screws (2) that secure the A/C-heater control to the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).