Pacifica V6-3.8L (2008)
Wheel Bearing: Service and Repair
Front Hub / Bearing - Removal
REMOVAL
NOTE: Replacement of front hub and bearing assembly can normally be done without having to remove steering knuckle from vehicle. In event
that hub/bearing is frozen in steering knuckle and cannot be removed by hand, it will have to be pressed out of steering knuckle. Steering
knuckle will then require removal before hub and bearing can be pressed out. See: Steering and Suspension/Steering/Front Steering
Knuckle/Service and Repair/Front Steering Knuckle - Removal
1. Raise and support vehicle. See:
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1). See: Service and Repair/Removal and Replacement/Tires and Wheels -
Removal
3. Remove cotter pin (1), lock (7) and spring washer (2) from halfshaft stub shaft (5).
4. With aid of a helper applying brakes to keep front hub from turning, remove hub nut (3) and washer (6).
5. Access and remove front brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal