Pacifica V6-3.8L (2008)
Parking Assist Distance Sensor: Service and Repair
Park Assist Sensor Bezel - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove rear fascia See: Body and Frame/Bumper/Rear Bumper/Rear Bumper Cover / Fascia/Service and Repair/Rear Fascia - Removal.
3. Disconnect the sensor electrical connector (2).
4. Using a trim stick or equivalent, gently pry out on the two retaining tabs (1) and pull the sensor (3) straight out of the retaining bezel (2).
5. If the bezel is either damaged or broken during removal of the sensor, gently press in on the bezel retaining tabs and then push bezel out of fascia.