Pacifica V6-3.8L (2008)
Fuel Gauge Sender: Service and Repair
Fuel Pump Module - Removal
REMOVAL
1. Remove fuel tank, See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Fuel Tank - Removal
CAUTION: Clean the area around fuel pump module prior to removal. Make sure this area is free of dirt. Failure to clean fuel pump
area prior to removal may cause dirt to get into the fuel system causing damage to the fuel system and/or engine.
2. Clean the area around fuel pump module with suitable cleaner and dry with low pressure filtered compressed air.
3. Disconnect vapor line and electrical connector.
4. Remove Fuel Pump Module lock ring.
NOTE: Use a brass punch to remove the 1/4 turn lock ring. Make contact only at the points shown.
5. Remove fuel pump module top.
6. Drain fuel from fuel tank with approved siphoning equipment, store fuel in approved fuel container.
7. Disconnect electrical connector.
8. The wire connector to the passenger side level sensor needs to be disconnected before removing the reservoir from the tank.