Pacifica V6-3.8L (2008)
Wheel Fastener: Service and Repair
Studs - Removal
Front
REMOVAL
NOTE: Use the following procedure to remove one of five studs on one wheel hub.
1. Access and remove front brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal
CAUTION: Do not hammer wheel mounting studs out of the hub. Damage to the wheel bearing will occur, leading to premature bearing
failure.
2. Install Remover (3), Special Tool 8677, on the hub flange (1) and wheel stud (2).
3. Tighten the Remover, pushing the wheel mounting stud out the rear of the hub flange. When the shoulder of the stud is past the flange, remove the
Remover from the hub.
4. Remove the stud from the hub flange.
Rear
REMOVAL
NOTE: Before proceeding, See: Brakes and Traction Control/Service Precautions/Brakes - Caution
NOTE: Use following procedure to remove one of five studs on wheel hub.
1. Access and remove rear brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal
CAUTION: Wheel mounting studs MUST NOT be hammered out of hub flange of hub and bearing assembly. If a stud is removed by
hammering it out, damage to hub and bearing assembly will occur leading to premature bearing failure.