Pacifica V6-3.8L (2008)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Installation
INSTALLATION
1. Place regulator into inner door panel.
2. Tighten screws attaching regulator and window motor to inner door panel to 9 Nm (80 in. lbs.).
3. Connect wire connector to power window motor.
4. Connect door glass to lift plate bracket. See: Window Glass/Rear Door Window Glass/Service and Repair/Rear Door Glass - Installation.
5. Install inner belt molding.
6. Install watershield. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door
Watershield/Installation.
7. Install door trim panel. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door Trim
Panel - Installation.