Pacifica V6-3.8L VIN L (2005)
SPEED SENSITIVE INTERMITTENT
WIPE MODE
There are 5 individual delay time settings with a minimum delay of 1.7 seconds to a maximum of 18.4 seconds. When the vehicle speed is less than 10
mph (6 km/h), the delay time is doubled, providing a delay range of 3.4 seconds to 36.8 seconds.
PULSE WIPE
When the wiper is in the off position and the driver presses the wash button for more than .062 seconds, but less than 0.5 seconds, 2 (possibly 3) wipe
cycles in low speed mode will be provided.
PARK AFTER IGNITION OFF
Because the wiper relays are powered from the battery, the BCM can run the wipers to park after the ignition is turned off.
WIPE AFTER WASH
When the driver presses the wash button for over 0.5 seconds and releases it, the wiper will continue to run for 2 additional wipe cycles.
MIST FUNCTION
The wiper operates as long as the wiper switch is in the mist position.
REAR WIPER
The rear wiper/washer system consists of the following features: mist wipers, intermittent wipers and wipe after wash. The rear wiper system is only
active when the ignition switch is in the RUN/ACC position. The vehicle operator selects the rear wiper function using the rear wiper switch integral to
the multifunction switch. The rear wiper switch is hardwired to the Body Control Module (BCM). Upon receiving a wiper switch signal, the BCM
provides 12 volts to the rear wiper motor. Rear washer occurs when the BCM receives a rear washer switch ON input. The BCM sends a PCI Bus
message to the IPM requesting rear washer on. The IPM activates the rear washer by providing a ground for the rear washer motor.
SPEED SENSITIVE INTERMITTENT WIPE MODE
The delay setting of the rear wiper system is based solely on the vehicle speed. The delay time is defined as the amount of time from the start of a wipe to
the beginning of the next wipe. The rear wiper system delay time is based on the following: 7.75 - mph x .05) = Seconds delay Examples:
At zero (0) mph the delay is 7.75 seconds.
At 100 mph the delay is 2.75 seconds.
WIPE AFTER WASH
When the driver presses the wash button for over 1.5 seconds and releases it, the wiper will continue to run for 2 additional wipe cycles.
Telecommunications
HANDS FREE PHONE
The vehicle telecommunications system consists of a Hands Free Module, Rear View Mirror, and a Blue-tooth Hands Free Profile enabled cell phone.
The system allows vehicle occupants to use voice recognition technology to make, receive and screen phone calls without physically handling a cell
phone. The system has a programmable phone book that can prevent the vehicle operator from becoming distracted searching for a specific number.
Seven different wireless phones can be programmed to operate each individual system. Each of the seven phones is given a rank of priority when
programmed.
Incoming phone messages are transmitted to the vehicle occupants through the vehicles audio system when the ignition is on and the wireless phone is
on. Upon receiving the signal from an incoming phone call, the vehicle audio system will fade out the current DVD/CD or radio output. The vehicle
occupants are then directed to accept or reject the call. Outgoing audio messages are received through the microphone located in the rearview mirror then
transmitted via hardwire to the Hands Free Module and finally transmitted through the wireless phone. Volume of the voice prompts and incoming
conversation is controlled using the vehicles' radio audio controls and steering wheel controls if equipped. The rear view mirror contains a Phone Switch,
Voice Recognition Switch and a microphone. The rear view mirror transmits these inputs via hardwired circuits to the Hands Free Module.