Pacifica V6-38L VIN L | Trunk / Liftgate Motor - Component Description | Page 7148
![background image](/chrysler/pacifica/v6-3.8l_vin_l/Page-2091001.png)
Trunk / Liftgate Motor: Testing and Inspection
LIFTGATE MOTOR
1. Open liftgate and remove D-pillar trim to access the power liftgate motor.
2. Using a DRB III(R) scan tool, actuate the drive unit motor to check operation. If a DRB III(R) scan tool is not available, disconnect the vehicle
battery and power liftgate module, connect a 12 volt power and ground source jumper wires to the wires coming from the DC motor. If the motor
rotates in both directions when the polarity is reversed, the motor is OK at this time.