Pacifica V6-3.8L VIN L (2005)
Trunk / Liftgate Motor: Service and Repair
Link Rod
REMOVAL
1. Open the liftgate.
2. Using a small flat-bladed screwdriver, pry the plastic retainer up to release the locking mechanism from the mounting sphere. Do not try to remove
the retainer, it is not designed to be removed.
3. Remove the link rod from the liftgate mounting sphere by gently pulling off.
4. Remove the D-pillar trim from the vehicle.
5. Remove the link rod from the drive unit mounting sphere by gently pulling off.
INSTALLATION
1. Install the drive unit end of the link rod on its mounting sphere by gently pushing straight on.
2. Push the plastic retainer down to lock the mechanism in position.
3. Install the D-pillar trim on the vehicle.
4. Install the liftgate end of the link rod on its mounting sphere by gently pushing straight on.
5. Push the plastic retainer down to lock the mechanism in position.
6. Close the liftgate and check for proper power liftgate operation.