Pacifica V6-3.8L VIN L (2005)
3.
Push back the left front wheelhouse splash shield and, using denatured alcohol, clean behind the lip of the front fender where it contacts the splash
shield in the two areas shown in (Fig. 1). Be sure the inside lip of the fender is clean and dry.
4.
Position the rearward piece of foam tape, 10 mm (0.5 in.) X 304 mm (12.0 in.) with the sticky side of the foam tape against the inner lip of the
fender between the fender and the front wheelhouse splash shield in the area identified as number 3 in (Fig. 1).
5.
Position the forward piece of foam tape, 10 mm (0.5 in.) X 152 mm (6.0 in.) with the sticky side of the foam tape against the inner lip of the fender
between the fender and the front wheelhouse splash shield in the area identified as number 1 in (Fig. 1).
6.
Repeat Step # 3 through Step # 5 on the right side of the vehicle.
7.
Return the steering wheel to center.
REAR REPAIR PROCEDURE:
1.
Using the foam tape, p/n 04318028, cut two pieces to a length of 304 mm (12.0 in.). Then cut each piece in half lengthwise. This will make four
usable pieces for the rear of the vehicle (two pieces in each rear wheel house opening).