Pacifica V6-3.8L VIN L (2005)
Fig. 40
f.
Install lift bracket/hook assemblies as shown in (Fig. 38) (Fig. 39) (Fig. 40). Tighten T-handles just enough to build tension between the fixture
and drivetrain.
3. Raise vehicle on hoist. Refer to Vehicle Lifting.
4. Remove both front tire/wheel assemblies.
5. If necessary, disconnect the wheel speed sensor harness from the support brackets to gain slack in harness.
Fig. 41
6. Disconnect sway bar links from struts (Fig. 41).
7. Remove lower control arm bolts to engine cradle and swing control arms out of the way.
8. Remove fascia. Refer to Front Bumper.
9. Remove engine front and rear mount-to-cradle nuts.
10. Disconnect brake hydraulic line and brackets from frame rails.
11. Remove the bolts and separate the brake line support bracket from cradle.