Pacifica V6-3.8L VIN L (2005)
28. Remove bolt and nut fastening stabilizer bar to each stabilizer link (Fig. 62).
29. Remove bolts fastening each stabilizer bar cushion retainer to crossmember (Fig. 62).
30. Remove stabilizer bar with cushions and retainers from crossmember.
NOTE: For installation purposes, when removing link fasteners, it important to note which bolt fastens what component and in what direction
each fastener is installed in.
31. Perform following to each side of rear suspension:
Fig. 63
a. Place a 13 mm 12-point box wrench over cable retainer on end of cable housing at crossmember and collapse retainer fingers (Fig. 63).
Remove cable from crossmember.
Fig. 64
b. Remove bolt and nut fastening spring link to crossmember (Fig. 64).