Pacifica V6-3.8L VIN L (2005)
18.
Disengage the black and grey fittings on handle cable from the latch mechanism (Inboard & Outboard). Load floor assembly is now free (Fig. 13).
19.
Disassemble the handle from the load floor. Remove the 2 release handle fasteners and pull the cables from the retention points in the load floor.
Remove and discard the release handle/cables.
20.
Position the appropriate new release handle in the seat back. Route and snap the cables into the retention points in the load floor (Fig. 14).
21.
Secure the release handle to the load floor with the 2 fasteners. Tighten the fasteners to 4 N.m (9 in.lbs.).
22.
Place the load floor and handle assembly on top of the frame and latch assembly. Fasten the load floor to the frame 7 places (Fig. 12).
23.
Snap the black cable fittings onto the latch actuation pin on both sides of the seat (Inboard & outboard) (Fig. 13).
24.
Snap the grey cable fittings into the eyelet on the latch on each side of the seat. Verify the fittings are fully engaged and the latches operate as they
should (Fig. 13).
25.
Secure both latch covers to the load floor with 2 plastic anchors each (one on the back of the latch cover and one on the side of the latch
cover)(Fig. 11).
26.
Position the foam and trim cover to the frame of the seat.