Pacifica V6-3.8L VIN L (2005)
Trunk / Liftgate Switch: Service and Repair
Exterior Handle Switch
REMOVAL
1. Open the liftgate.
2. Disconnect and isolate the negative battery cable.
3. Open the liftgate and remove the liftgate trim panel.
4. Disconnect the handle switch electrical connector.
5. Remove the liftgate handle assembly from the vehicle.
6. Depress the two exterior handle switch retaining tabs and roll the switch out of the handle assembly.
INSTALLATION
1. Install the handle switch in the handle assembly.
2. Install the liftgate handle.
3. Connect the liftgate handle electrical connector.
4. Install the liftgate trim panel.
5. Connect the negative battery cable.
6. Using an appropriate scan tool, check and erase any power liftgate module diagnostic trouble codes.
7. Verify power liftgate system and handle switch operation. Cycle the power liftgate through one complete open and close cycle, this will allow the
power liftgate module to relearn its cycle with the new components.