Pacifica V6-3.8L VIN L (2005)
Wheel Speed Sensor: Service and Repair
Rear
WHEEL SPEED SENSOR REAR
REMOVAL
1) Access and remove rear hub and bearing from vehicle.
CAUTION: Prior to removal, clean area around sensor head to help prevent contaminants from entering bearing when sensor head is removed.
2) Remove screw fastening speed sensor head to hub and bearing (Fig. 4).
3) Remove wheel speed sensor from hub and bearing.
INSTALLATION
1) Apply bearing grease (supplied with part) to sensor head shaft and O-ring.
CAUTION: Ensure that sensor mounting surface on bearing is clean before sensor installation.
2) Push sensor head into mounting hole in hub and bearing and align mounting screw hole.
3) Install NEW mounting screw (Fig. 4). Tighten mounting screw to 20 Nm (15 ft. lbs.) torque.
4) Install hub and bearing with wheel speed sensor as well as all components necessary to access it.
5) Road test vehicle to ensure proper operation of the base brakes and ABS.